Some guests sometimes encounter the situation that when the screen is completely closed, the top cover does not go down completely, leaving a gap, please see the picture below:

Some guests sometimes encounter the situation that when the screen is completely closed, the top cover does not go down completely, leaving a gap, please see the picture below:

1. First, you can contact the customer service to ask for the repair video of the upper cover gap

2. When the screen is closed, the left upper cover cannot be fully closed. In this case, you can watch this video to learn how to adjust and fix it.



3. Open the glue cover

4. Insert the yellow adjusting rod into the white hole of the motor through the housing hole.

5. Turn the lever one third of a turn counterclockwise.
After turning, please press the switch first and then press the switch, the top cover will be lower than the original position.

6. If the top cover is still not aligned with the case after the screen is turned off,
You can rotate the adjusting lever counterclockwise several times a third of a turn until there is no gap between the cover and the housing.


7. If the black edge is still not enough, you can adjust the black edge repeatedly by rotating the adjusting lever clockwise.

If you adjust too much counterclockwise, it will cause the problem of exceeding the upper limit height.